V-110 lever sticks in the down position

Hi guys, it's been a long time.

So here's the deal. After having my V-110 for almost a year and it working well, recently the lever has been sticking in the "down" position almost everytime that I vend.

Incidentally, it is on "free vend", but that should not matter at all, because it was on "free vend" when it worked great earlier.

Anyway, when I want a bottle, I push the lever down all the way, and instead of it popping back up to the starting position again (and me grabbing my bottle), it stays stuck down. I then must whack it many times with the heel of my hand until it eventally comes loose and rises back up to the starting position.

It kills me (and I'm sure you) to be whacking the antique lever, but that is the only way I can get my drink each time.

It is very annoying for me (because I use it many times each day in my kitchen), but more importantly, it is embarrassing when friends and company come over and I go from being cool (by having my soda machine collection) to a dork by whacking the "broken" machine after each person tries to get a drink.

Have any of you guys (and gals) experienced this? What can I do to fix it?

Help!  '>

[MoonDawg]

Welcome back Kito, and yes.........this has happened to a lot of us so relax. This forum is to address these issues.
        If you have the small coin mech. I may be able to help. Remove the slug rejector and looking down the mech. to your left of the crank handle is a little cog that rachets against the handle assembly.  It's purpose is to make sure the user pushes it to it's full throw.  When the handle is returning you will hear it clicking against the teeth.  You probably need more tension on that return spring.  (the cog and spring are much more visible by looking under the mech.)

[jasmine64]

Well, I was going to ask if it's spring loaded, but looks like Moomdawg
answered the question.

Glad to have you back. Stop by more often.

Thanks guys.
How do I put more pressure on the spring?
Do I replace the spring? Or can I do something to it?
Thanks.

[MoonDawg]

Try cutting it a little shorter and re-bending your loop at the end as a hook

[sodaworks]

Try adding a drop of penetrating oil on it as well. Then reach up into the cog and move it a few times. '>

[90grad]

Just a thought, but could the problem not be with the return spring on the crank but with the mechanism at the bottle stack?  If this is binding for some reason, would it prevent the linkage from moving, which would hold the crank?  A quick way to check would be to push down the crank when the door is open.

Sorry in advance if this has no relevance.  What made me think of this was the crank on my Cavalier 51 returns slowly and I know the problem is with the ratchet mechanism in the cabinet.  I just haven't torn it off to lube/replace bearings.

[MoonDawg]

Well Wayne I had to rule out the bottle stack or door linkage when Kito described having to use Kung-fu methods on his machine to release his handle. '>
      Did you get my pkg?

[90grad]

Glen, I haven't seen a package.  I'll let you know when I do.  Glad to see Kito is around again.

[sodaworks]

Kito,
 If your still having problems try taking the coin mech. off and remove the slug rejector. Get you some solvent in a aresol can and spray the mech. really good. Actuate the mech. a few times and spray some more. Repeat this a few times and apply a couple of drops of lube to the actuating shaft. '>