Transitional Coin Mech / small door coin mech - Free Vend

[Jonathan816]

I know free vend is possible, however I'm wondering if there is something that looks a little nicer than this.

[MoonDawg]

      Good question, this is asked a lot.
      Someone will answer you soon............... hopefully accompanied by a picture just like you presented.

[collecture]

Use a 6-32x3/8" screw.
The screw hole on the left lifts the nickel lock lever. The right one lifts the dime lock lever.
The screw pushes the bottom of the lever lifting it off the shaft.

[Jonathan816]

Use a 6-32x3/8" screw.
The screw hole on the left lifts the nickel lock lever. The right one lifts the dime lock lever.
The screw pushes the bottom of the lever lifting it off the shaft.

Perfect Thanks - worked like a charm


Moderators - Can we lock this to the top of the coin mechanisms post?   This would be helpful for everyone.

[ZiaDan]

Thanks for the information!

[collecture]

Moderators - Can we lock this to the top of the coin mechanisms post?   This would be helpful for everyone.

This, obviously, works on all small door mechs also (i.e. VMC-27/33, BV-56, V-39/81/110, C-33/51)

[Ltransam]

Toms The MAN!!!!!!!!!!!!

I Also learned it from Tom