Galaxie tap handels

Really great work!
Way to find a way to get what you need.

[BrianB]

Man, those look awesome. Did your buddy use a standard CNC, water jet or a regular old milling machine? That's a great hook-up you have!

[Ltransam]

Hello,Everyone
          
               Thank's for the response's '> Yea the machine shop guy's In my shop are COOL!!!
These were made without a sand casting. So a LOT of thie flying under the radar from the big boss.(Real cost would have been $35 .00 each But Mine are FREE Yea !!!.I only had 8 made because of the little Instrest in producing them .Cost just to have a sand casting made (My out of pocket)$200.00 + Piece Price.And these turned out Much Nicer & got them ingraved '>

 VMC117BMB=Brain these were first set-up in a Brigeport & edge squarrd .Then turned-up on there side & Drilled & Taped The shaft holes .Then put on the Fadal CNC Machining Center
cut out & ingraved .

Then shaft was turned down on a manual lathe with a 4 jawed chuck at 7 1/2 degree angle.

 Then I used a de-burring wheel to blend the shaft in to the main body  

                                     Ltransam