|
johnieG
|
 |
« on: April 01, 2008, 09:25:36 pm » |
|
here's a tip for knowing what pin is what on a Tecumseh compressor. added an OHMS test picture to help 'yall test for open start-run windings...and it only took 6years!
|
|
|
|
« Last Edit: January 18, 2014, 07:30:41 pm by johnieG »
|
Logged
|
Spoon-feeding Newbies since 2001...  Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan. |
|
|
|
sodaman
|
|
« Reply #1 on: January 11, 2011, 10:45:55 am » |
|
That info helps, what compressor does a Cavalier 72 have? The pin placement is a triangle with the single post on top, and the wiring diagram says start, run, common, is that the same as the tecumseh?
|
|
|
|
|
Logged
|
VMC 81:RC, 7UP Pepsi
Jacobs: 26(4), 160, 35, 50, 56
Quikold RC, Orange Crush, Barqs
General Vending Leader , Master & Midget(THE DALY 32)
American Vendor 124
Guiberson, DP 27 W/stand
VMC 33 7UP, Pepsi
Mills 45, 47A, 120 W/bottle display
2 Delf Triples VMC 72
70+ soda Venders, 6 Stoner
|
|
|
|
johnieG
|
|
« Reply #2 on: January 18, 2014, 07:29:32 pm » |
|
Added a new diagram/drawing...kinda an update...(for Pixel)
|
|
|
|
|
Logged
|
Spoon-feeding Newbies since 2001... Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan. |
|
|
|
Pixel
|
|
« Reply #3 on: January 18, 2014, 07:32:17 pm » |
|
Added a new diagram/drawing...kinda an update...(for Pixel)
Thank you, johnie. Might I add, if any of these three terminals is grounded through the compressor case, the compressor is bad and will need to be replaced. Isn't that right? |
|
|
|
|
Logged
|
|
|
|
|
johnieG
|
|
« Reply #4 on: January 18, 2014, 07:35:54 pm » |
|
You are correct sir.. any reading from the (isolated) terminals to ground ( or the bare metal case of the compressor) it's done for (the compressor) unless you don't have a ground pin on your line cord, then it will be the end of the road for you.  |
|
|
|
|
Logged
|
Spoon-feeding Newbies since 2001... Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan. |
|
|
|
johnieG
|
|
« Reply #5 on: January 18, 2014, 07:45:25 pm » |
|
Semi related photo...sort of
|
|
|
|
|
Logged
|
Spoon-feeding Newbies since 2001... Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan. |
|
|
|
BrianS
|
|
« Reply #6 on: January 19, 2014, 12:38:29 am » |
|
This might seem a bit hokie, but for either pin out configuration I just remember that the word "compressor" starts with a "C", ends with an "R", and has an "S" in between. Moving, right to left and top to bottom, both pinouts go from Common, to Start, to Run. So it starts with a C, ends with an R, and has an S in the middle.
Sounds like an episode of Sesame Street, but always works for me.
|
|
|
|
|
Logged
|
Brian
Vendo 56 - restored
Vendo 81 - in progress
Vendo 39 - in the rough
Rockola 1428 - Original
1959 Williams Pinch Hitter
Wurlitzer 1400
1930 Koken Barber Pole
|
|
|
|
johnieG
|
|
« Reply #7 on: October 23, 2020, 01:54:01 pm » |
|
a small picture update to help ID the compressor pinout types...
|
|
|
|
|
Logged
|
Spoon-feeding Newbies since 2001... Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan. |
|
|
|
BrianS
|
|
« Reply #8 on: October 26, 2020, 01:17:22 pm » |
|
This is a great resource. Should be thumbtacked to the top of the page
|
|
|
|
|
Logged
|
Brian
Vendo 56 - restored
Vendo 81 - in progress
Vendo 39 - in the rough
Rockola 1428 - Original
1959 Williams Pinch Hitter
Wurlitzer 1400
1930 Koken Barber Pole
|
|
|
|
johnieG
|
|
« Reply #9 on: October 26, 2020, 09:19:21 pm » |
|
It’s already there grasshopper
|
|
|
|
|
Logged
|
Spoon-feeding Newbies since 2001... Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan. |
|
|
|
