Vendo 81 a 6 cent coin mech

[hacksaw707]

Thanks for the replies, soaked it simple green and water, giving it a a good cleaning. I will see what happens. The penny is hanging up on the washer pin.

[Larry]

I think Tom once mentioned he used a dishwasher before?

[MoonDawg]

I think Tom once mentioned he used a dishwasher before?

     Tom is married.......he doesn't need to know how to use a dishwasher! 

[cmike101]

So wrong. (MOON) But that was cute !

[hacksaw707]

The pennies are getting stuck at the magnet, I pulled and cleaned this area but they are really tight. I can push them through ; but they can't pass on the there own. I'm trying to figure out how to post pictures on this site......

[ajf5577]

Hmmm, are they the newer zinc pennies. I didn't think they were magnetic. Try using pennies made before 1982.
I'll have to get an older rejector out and try it.

[hacksaw707]

I've tried many different years of coins, they just won't pass through the magnet?

[ajf5577]

There is a pinned post at the top of the General Chit Chat page that discusses file attachment sizes.
its fairly easy once you figure it out.

Is the door on your rejector missing a stop at the end opposite the hinge side? If the coins are sticking at the magnet, it may be that the door is not allowing enough clearance. Did this situation just start?

[Creighton]

Send whatever photos you have to cjs@lost-coast-designs.com. Will resize and post for you.
Simple Green if not scrubbed and rinsed well leaves a mess. Try hot water and an old toothbrush to get all clean. If no air compressor a hair dryer on high to dry.

At lot of times it just takes a few try's to get the bits working.
Creighton

[SIGNGUY]

unless your worried about kids or friends sticking slugs in there, you could just remove the magnet?