Vendo 56/81 large door

[MaineT]

Oh, the bezel is another $100-125!!!!

[Slider-Bob]

Robert in Chicago and I just talked again.  Tyler and Ron Dale are heading to Robert's shop tonight. Robert said Ron called him the other day and asked him to help him buy some machines while at the show.  I was tempted to say I had a v39 that was once converted into a c72 if they had any interest. LOL  

[Cokemachinesandmore]

any chance Robert in chicago, has a last name of kennedy?

[tkaz]

So another question, was this the right slug rejector for the mech?  I didn't buy it, but can easily stop back by tomorrow and grab it, I don't think it'll be gone.

[MaineT]

The extra handle beside the mech for $50 is a good buy too, they can for $75 and up

[tkaz]

Huh, so I should grab that handle for the $30 they were asking too!  Fortunately, prices weren't as marked

[Slider-Bob]

any chance Robert in chicago, has a last name of kennedy?

I have no idea what Robert's last name is. He had posted an ad on CL saying he buys upright coke machines.

[MoonDawg]

So another question, was this the right slug rejector for the mech? 

           No, I think Tom will confirm the rejector is for a large door mech.
           Even though you do have a large mech. it is actually Vendo's earlier small mech. mounted inside a large shell.
Uses the same rejector as V-39, VMC-33 etc.

[collecture]

           No, I think Tom will confirm the rejector is for a large door mech.
           Even though you do have a large mech. it is actually Vendo's earlier small mech. mounted inside a large shell.
Uses the same rejector as V-39, VMC-33 etc.

Correct!

[tkaz]

Huh, so can the small door mech be removed and used as-is (if I added the right slug rejector) or should I just leave it like it sits?