Vendo 23 parts sale

[90grad]

All,

Here is the first of a few messages with the photos of the Vendo 23 parts I am selling.  I have no idea on prices, so make me an offer.  If no one here wants something, it's going on GreedBay.

I have other small items, so if you don't see something, just ask.  I have some body pieces.  The top and disk I have are in pretty decent shape with a some surface rust on the disk.  I do have a bottle door, but no hinge pin or spring.

This post has two photos of the bottle basket.  You can see it is in very good shape and just needs a good cleaning.  There is some surface rust on the brackets underneath, but there is no real structual damage.

[90grad]

Here is the coin entry plate WITH the sold out window.  The window is not attached, so I could sell this separately.  I think the window sells for $12 from Funtronics.  It has some discoloration around the edges where the glue was, but the center is in good shape.

[90grad]

Here is the drain channel.  It has some pitting.

[90grad]

Here is the COMPLETE evaporator coil and capillary tube.  I spoke with Eric at Global and said this just needs to be mated to a lower end assembly.  I was careful not to alter the length of the cap tube, as that would affect the system.  The line was cut right at the compressor.  This has been kept in a dehumidified room with aluminum tape over the open ends.

[90grad]

Here is the service manual.  I ordered this off the net and can send either this one or a .pdf file.

[90grad]

Here is the coin mech WITH the sold out flag.  I could not find the coin return rod, but I will keep looking.  I tested this the other day with a dime slug rejector and it worked properly.  There is some surface rust, but this should clean up nicely.  The star handle has a fair amount of pitting in the chrome.

UPDATE: This has been sold to GMiller.

[90grad]

Here is the tank for the bottle basket.  It does have some surface rust, but is mainly dirty.  I didn't have time last night to clean it up before taking pictures.

[90grad]

Here is the trim for the bottle opener and coin return cup.  I have an extra bottle opener trim.  These are in pretty good shape.

[90grad]

Here is the bottle door.  It doesn't have a pin, spring or gasket.  The paint on top is dulled.  There is a very small amount of surface rust on the handle and hinges.  Overall, it's in excellent shape - very straight.

UPDATE: This is has been sold to Ltransam.

[90grad]

Here is the top and spin disk.  However, I will separate these if some one desires.  Both are very straight.  The top has very little surface rust and the disk has a lot of surface rust underneath.  Nothing is through.

I also have the cover that goes on the underside.  That will be posted in the next reply.