SMC Discussion Areas
March 29, 2024, 01:47:38 am *
Welcome, Guest. Please login or register.

Login with username, password and session length
News:
 
   Home   Help Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Coinco 9370S Tuning Steps  (Read 4304 times)
0 Members and 1 Guest are viewing this topic.
tkaz
Soda Jerks
*****
Offline Offline

Posts: 1900

tkaz


WWW
« on: July 18, 2016, 09:32:30 pm »

Does anyone happen to know the Coinco 9370-S tuning steps, or have a link to the image in the manual that shows them?  I can download the manual from the Coinco site, but they messed up the scans and the page I need is 15, and the manual goes 13, 14, 14, 16...   veryangry

I have looked at a lot of the other 9300 series manuals and they don't have the coin tuning steps available.

Thanks in advance.  help drinking drinking
Logged

Fire708
25 Cent Member
****
Offline Offline

Posts: 317



« Reply #1 on: July 24, 2016, 12:25:19 pm »

My manual and the ones I found online all say it's in section 4, page 15. The thing is they all have two page 14's and then page 16.  darn

I did find this
http://www.coinco.com/index.php/support/downloads/category/7-coinpro-3-9300-series?download=11:9300-s-series-electronic-changers-op-and-service-manual

For a similar coin mech from the same series. The steps in this one MAY work.
Logged
tkaz
Soda Jerks
*****
Offline Offline

Posts: 1900

tkaz


WWW
« Reply #2 on: July 24, 2016, 09:36:46 pm »

Thanks, I was wondering if the manual that others are selling has the error too, looks like it.

I'm trying to remote troubleshoot this one, so I was hoping to find the steps to tune.  Instead I am going to have to send one of my good mechs and have them send theirs back so I can work on it in house.  I'll update if I figure it out on my own.
Logged

Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.15 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!