Coinco 9370S Tuning Steps

[tkaz]

Does anyone happen to know the Coinco 9370-S tuning steps, or have a link to the image in the manual that shows them?  I can download the manual from the Coinco site, but they messed up the scans and the page I need is 15, and the manual goes 13, 14, 14, 16...   

I have looked at a lot of the other 9300 series manuals and they don't have the coin tuning steps available.

Thanks in advance. 

[Fire708]

My manual and the ones I found online all say it's in section 4, page 15. The thing is they all have two page 14's and then page 16. 

I did find this
http://www.coinco.com/index.php/support/downloads/category/7-coinpro-3-9300-series?download=11:9300-s-series-electronic-changers-op-and-service-manual

For a similar coin mech from the same series. The steps in this one MAY work.

[tkaz]

Thanks, I was wondering if the manual that others are selling has the error too, looks like it.

I'm trying to remote troubleshoot this one, so I was hoping to find the steps to tune.  Instead I am going to have to send one of my good mechs and have them send theirs back so I can work on it in house.  I'll update if I figure it out on my own.