Pre-war Stoner/Univendor Display Glass

[MaineT]

I took mine out so I can't answer if 1/8 would be a dealbreaker. I wouldn't think so, but that would just be a guess.

[Jim]

I picked up the display glass and I am very happy with the replication!
I posted a photo of the original and the new glass...  You be the judge

As far as the 8 selection display glass is concerned, I will use the 7" height by 24 13/16" wide; however, can Wojcik & MaineT measure their display glass opening height on the cabinet door...?
I want to compare my opening size to the larger model. I realize there is only 1/8" difference in height but I'm just covering all the bases! These were a little pricey and mistakes would be costly ! ! !

Thanks everyone!

[Eric]

Is that screened onto the glass?.. That looks awesome!

[Jim]

Is that screened onto the glass?.. That looks awesome!

Eric,  It's not silk-screened; it's a decal
And Thanks for the compliment!

[mznb1u]

Jim,

Looks great!  I will post some pictures of the frame that hold the glass on my 8 pull but I think your measurements are good.  The frame outside opening measures 24 1/4" wide and the exposed part of the opening is 7" high.  On the inside of the frame, there is a lip that is 1/4" in from the frame opening on the sides and bottom of the frame that hold the pane of glass.  The top of the frame is hidden inside the machine and is open to allow for sliding the glass in which would allow for a taller piece of glass and likely explains why the replacement glass in my machine is bigger than necessary.

Hope this helps.
Tim