Looking for CSS-96 (or CS-96C/E) door liner and other parts

[brasskey]

UPDATE 04/22/12 - Just needing bottle opener bezel now

As this is a larger machine I know that these liners are probably not reproduced.  Obviously liners for CS-64C/E can be found new, but I assume these larger ones cannot.  I know I could easily get the same thickness of plastic and have one cut (since it is all mostly flat), but I dont' know how I would accomodate the bulge at the bottom where the wires and tubes go up from the compressor.  Anyone have a used one in good condition?

Also, the bottle opener hole is larger than what I've seen on these Cavalier machines.  Anyone know where I can get a larger bezel?






Lastly, where can I get a lock mechanism to complete this door handle?

[brasskey]

Sorry, I just realized I put this in pre-60s machines. Please move if needed.

[brasskey]

Still looking for a few parts for this machine (liner, bottle opener trim, and lock mech).  I just got it back from soda blasting and now it's on to body and paint.

[Funtronics]

We have the T bar lock and handle. The door liner you will have to fabricate.

[briandr1]

I have an early 60's cs 96 for parts I will look at the door liner and see what condition its in and let you know.


Brian

[brasskey]

We have the T bar lock and handle. The door liner you will have to fabricate.

Thanks. I will find the lock on your website.

I have an early 60's cs 96 for parts I will look at the door liner and see what condition its in and let you know.


Brian

Please do. That would be great if it's in decent shape.

[briandr1]

I had a look at it today it has a crack but no missing pieces ill take a pic of it and post it so you can see it. other than that its nice and in decent shape

[brasskey]

I had a look at it today it has a crack but no missing pieces ill take a pic of it and post it so you can see it. other than that its nice and in decent shape

Better than what I currently have.  Mine disintegrated on the edges when I took it off (combination of being screwed down too tight and the age of the plastic).  I'd like to see a pic when you have time. Thanks.

[briandr1]

It looks good so far let me take out the screws to make shure mine doesnt have the same issue yours did Ill check it out this weekend. and the good thing is if you do need it im only 100 miles south if you.

[brasskey]

We have the T bar lock and handle. The door liner you will have to fabricate.

Please check your PMs.  I messaged you last week to see if I located the correct lock on your website.
 

It looks good so far let me take out the screws to make shure mine doesnt have the same issue yours did Ill check it out this weekend. and the good thing is if you do need it im only 100 miles south if you.

Great, thanks so much for looking into it.  Where are you located?