Vendo v192-6 won't vend

[BrianB]

Hmmm.....sounds like it "wants" to vend. I'm not sure on that model if there is a direct way to actuate/cycle the vend motors like you can on old Choice Vends. I'm thinking there is but not 100% sure.

Guy's/Gal's, what do you think?

I have tested each vend solenoid with a std. plug with ends cut off - 120v.  Every one of them fired.  Is this sound evidence that each one is work properly?  Perhaps a broken/loose wire conn. is not allowing power to the solenoid.  Or maybe a cancel switch is stuck closed...any ideas?!?

[khentige]

i know this is an old thread but maybe this can help the next guy (or gal),

So in the above scenario the free play switch is activating the 1st relay in the circuit because you have paid. in order for the select switch to activate the selected slot motor, all motors have to be installed as the 115VAC goes through all of the motors relay switches in series and then back to the 2nd relay, awaiting you to make a selection.

just my 2cents. Good luck.

Ek in CT