Help needed changing litebulbs...

[cokentn]

My light in the front door, the big one behind the big red logo is flickering, like it's getting ready to go out.
I've never had it out, and I've never changed one either. I don't see any screws to remove the cover.
How/where to remove/what size bulbs and such goes on here?
Thanks!
Mark

[MoonDawg]

        First, open the coin door and look up under the liggh panel. If you don't see
2 screws or wingnuts then open the main door and look on the top or side for them.
Once they are removed the panel will need to be pryed out as it's a tight fit.
        As for the bulb..............remove it and take it with you to your lighting store.

[collecture]

If I were you, I'd go ahead and install a new ballast and starter while you are at it. Cost is $10-$15 total and you'll have no problems for a long while!

[cokentn]

I found two small phillips screws on the bottomside of the sign. Actually, the are up in two small holes that I didn't see before.
Now..they are just not budging and I don't want to strip them.
There is about 3-4 inches of clearance between them and the strip/panel thing with the drink buttons on it. It flips down.
I guess I'll have to remove that thing, so I can get a longer phillips up in there and tap em?
dunno...
WHY would they make that so hard to get to?
IN 1971 were people stealing Coke lightbulbs?

[MoonDawg]

IN 1971 were people stealing Coke lightbulbs?

 

    LOL.......welcome to the fun and frustration of old soda machines 

[Pat Pixley]

What kind of machine is it  ?  Vendo or Cavalier 
If Cavalier they have to screws on the main door  then
the Frame for the Marquee  has two pins .
 Vendo's  have the screw on the under side when you
open the coin door.

    I would change the  whole thing out , this is what I did.
I think I took this from Josh and ran with it.

[loman4ec]

Yep that is what I use. It is much easier then replacing the balast, starter and bulb. Just go to home depot and instal a new lighting fixture.

[cokentn]

It is a Cornelius type 120.
Not many were made.
Here is my album:
http://soda-machines.com/g2/gallery2/main.php?g2_itemId=3379

[cokentn]

I was finally able to get that off and get to the bulbs. It was odd. The screws that held it in place were not the ones I thought would be. One was actually a wire holder as well as one to hold that front cover in place.
I will try later today to get those replacements. I did get the ballasts out too, they were FS-25.
The bulbs are F25T12CW-78.
I hope they still make those.

[Pat Pixley]

Mark we also have to find you a coin catcher, the tin can just does not
look right    .It is a great looking machine other than that .