Just got a CSS-64

[MoonDawg]

     It might be cheaper to take 1 of your shelves to a sheet metal shop for
reproduction, since shipping has become more expensive than you may realize.

[johnieG]

I just had a complete set of repro shelves on Ebay for the CS64 they go for $125/set of 8 + shipping if you are interested at all.

or if you decide to have them duplicated at a local metal fab shop. be sure they use a heavy enough gauge of metal.

[MoonDawg]

or if you decide to have them duplicated at a local metal fab shop. be sure they use a heavy enough gauge of metal.

 Good point JG.......I can imagine a full shelf that is sagging, is of no use at all 

[Skeleton Man]

I just had a complete set of repro shelves on Ebay for the CS64 they go for $125/set of 8 + shipping if you are interested at all.

or if you decide to have them duplicated at a local metal fab shop. be sure they use a heavy enough gauge of metal.

I only need 4, so I would have to split with somebody else (no use paying shipping for the lot when I only need half). Wasn't there someone else looking for CSS-64 shelves ? (under swap meet, someone looking for 3 shelves)

If anyone wants to split the full set with me then I'll take it.

Thanks for the tip re the gauge of metal. I was looking a metal shop in toronto, sent them an email with photos asking if they can repop the shelves. If they say yes I'll probably make the drive down there with an original for them to measure (about 3 hours each way).

Chris

[johnieG]

Here is what mine look like ( this is a prototype in the picture, so the index-tab on the right isnt notched out yet) Pat pixley's seen them & I think they turned out nice.

[loman4ec]

Johnny, That shelf is for an early model 64. Chris needs shelves for a G model. They are very different.

[johnieG]

That's why I thought I'd post the picture! Thanks

[Skeleton Man]

J model actually, not G.