|
Skeleton Man
|
 |
« Reply #20 on: February 15, 2007, 02:03:04 pm » |
|
Flat spades are pretty common, the two most common layouts I have seen are below.. let me know if either of those are correct..
|
|
|
|
|
Logged
|
|
|
|
|
Guest
|
|
« Reply #21 on: February 15, 2007, 04:43:41 pm » |
|
Yes mate it is the one on the left except there is a ting bit bigger gap between the top nine and the bottom two but layout is correct. Did get a quote for a online company in the US for $21.90 US easch plus postage, a little high I think but when I get call for Oz distrubutor maybe that is right.
|
|
|
|
|
Logged
|
|
|
|
|
Skeleton Man
|
|
« Reply #22 on: February 15, 2007, 07:40:12 pm » |
|
USD$22 each + postage ? That's highway robbery in my opinion (though sadly I don't doubt that's their price). These are miniature relays right ? The spec sheet says they're like 3cm long by 2cm wide..
Still trying to find an alternative or somewhere cheaper..
|
|
|
|
|
Logged
|
|
|
|
|
|
|
Skeleton Man
|
|
« Reply #24 on: February 19, 2007, 03:18:43 am » |
|
$15.90 AUD ? That's a little more reasonable.. which supplier did you find them through ?
|
|
|
|
|
Logged
|
|
|
|
|
Guest
|
|
« Reply #25 on: February 19, 2007, 04:42:28 pm » |
|
It was some elctircal supplier list on Fuji Electrics webpage located in adelade, hopefully they will be here tommorrow then I can test and see if it is the coin mech that needs replacing if so work out what one to put in and where to locate it.  '>
|
|
|
|
|
Logged
|
|
|
|
|
Skeleton Man
|
|
« Reply #26 on: February 19, 2007, 05:07:29 pm » |
|
Good luck with it mate.. coin mechs are a dime a dozen, assuming it's 110V and uses a Jones plug.. (8 flat pins and a round guide pin in the middle)
Might be a costly exercise to reprogram one for ozzie dollars though.. (I've never seen an older ozzie $$ mech.. only new serial/digital ones)
|
|
|
|
|
Logged
|
|
|
|
|
Skeleton Man
|
|
« Reply #27 on: February 20, 2007, 06:54:30 pm » |
|
Just a FYI.. I emailed Coinco about a 110V single price mech for Australian currency and they pointed me towards the ALD-F707 mech.
Here's a link to their site: Coinco ALD-F707
Chris
|
|
|
|
|
Logged
|
|
|
|
|
Guest
|
|
« Reply #28 on: February 20, 2007, 07:53:31 pm » |
|
Hey Chris,
Thanks heaps the parts arrived today will reassemble system soon and put back to together and fingers crossed it all works or I will contact coinco and get a new one.
Cheers and Beers
Vossy  '>
|
|
|
|
|
Logged
|
|
|
|
|
|
|
