We-6 agitator motor
johnieG:
No problem, glad to help, Dlyle, just make sure it's the right length, yours may have an old rubber shaft coupler between the motors shaft and the circulator paddle, measure the length from the face of the motor to the end of the shaft to confirm, also double check which end you need, a flat, or a 1/4-20 thread-end, you know where to go if you need any more info! let us see some before and after pic's of the motor assy if you can! (and the cooler too!)
johnieG:
Here's apic of the Graingers motor ( with the threaded end) look familar?
Jim:
Excellent resource Johnie!
You continue to amaze me!!!
Johnie,
On topics like this, you could Pin them as I have done for this one so they stay at the top of the list...
:
Hi Guys. I'm a little confused now. It says the motor runs CCW but when I look at it it apears to run clockwise. I'm looking at the impeller right now, looking from the bottom of it (the end opposite where it attaches to the motor rubber coupling) and it spins clockwise. The impeller blade is correct, I have another working machine to compare it to. It spits water out the top and everything. I've talked to Steve at funtronics and his catalog also says CCW. Are we sure it doesn't mean CCW as viewed from the top of the machine?
Thanks again, Doug
:
I looked at one of my other motors for reference. The fan motor for the condensor says it's a CW motor...and it does turn clockwise, but only as viewed from the motor side, not the shaft side.
Thanks, Doug
Navigation
[0] Message Index
[#] Next page
[*] Previous page