We-6 agitator motor
:
Hi. I have a we-6 wet cooler that has a broken cast iron agitator motor. Can these be fixed or is there a good replacement available for it?
Thank you, Doug
johnieG:
Yes! it's avalible as a repro-Item or check out Graingers part No. 5M067 , Cast Iron "Unit Bearing Water Agitator", rated@15watts 115 VAC, 1500 RPM,CCW rotation (as viewed from the shaft end.) shaft spec's are: 5/16" x 7" with a 1/4-20 thread on the end, about $78.00 or part No. 5M068 same spec's but 5/16" x 5" long,with a 1" long flat machined onto the end of the shaft, (for a coupler) about $74.00
Hope this helps!
:
Thanks for the response Johnie. Will it be a problem that this motor spins faster? I think the other one was less than 1000 RPM's. Also, do you know if the grainger one is a direct bolt in or does it take an adaptor?
thanks again, Doug
johnieG:
Naw 500 RPM's extra will only circulate the water around the tank a little faster is all, yep it bolts right up using the same three mounting holes to the bracket, if yours has only two screws mounting it to the bracket you can still use it with an adapter plate either part No. 1C897/~$6.00 or No.4M738/~$3.00 goto www.grainger.com and checkout their
online catalog for pictures, etc.
:
That's great news. Mine has the 3 mounting holes so it should work perfect. Lokks like I need to place an order.
thanks again Johnie!
Doug
Navigation
[0] Message Index
[#] Next page