We-6 agitator motor
Jim:
Hello again,
I just checked and wasn't able to post without being logged in for almost all the Discussion Areas; I didn't manually check everyone...
The only thing I can say is that due to the dates, I may have had a setting improperly set and found it later only to correct this for later posts...
Yea, that's it, that's what the problem was...
dr galaga:
Oooops! I didn't notice that it was from 2 1/2 years ago (no wonder it seemed like a new topic to me!).
90grad:
Does Grainger (or anyone) carry the blade to go on the agitator motor JohnieG referenced earlier in this post? Grainger has some fan blades that look as if they would fit, but they would push the water down instead of up. I can't tell if you could mount them upside down or not. Anyone have experience with this?
Jim M:
Hello all, any updates on this as I have a WE6 with the same issue....
can the machine be run without the agitator running?
thanks, jim
90grad:
You need the agitator motor to run to circulate the water. Otherwise, you won't get proper cooling. One of the sponsors to this site, Funtronics, carries both the motor and blade.
Navigation
[0] Message Index
[#] Next page
[*] Previous page