|  | 
	| 
			| 
					
						| MoonDawg | 
								|  | « Reply #1 on: August 12, 2006, 12:50:52 pm » |  | 
 
 I like it! Very uniform looking.Look in your phone book under "specialty lighting" for the bulb.
 |  
						| 
								|  |  
								|  |  Logged | 
 
 Glen |  |  | 
	| 
			| 
					
						| Creighton | 
								|  | « Reply #2 on: August 12, 2006, 01:14:07 pm » |  | 
 
 Great looking machine!!Creighton
 |  
						| 
								|  |  
								|  |  Logged | 
 |  |  | 
	| 
			| 
					
						| 
								Guest
 | 
								|  | « Reply #3 on: August 12, 2006, 02:34:08 pm » |  | 
 
 found them, they keep them in stock at this little light store, they are 10 bucks each though.  when i put the light in, it kinda flickered then went out.  i wonder if it is the ballast?  i took the ballast out and looked at it but i don't think you can tell when they are fried just by looking at them, so it's off to Lowe's to see if they have one.  just hope i didn't blow the brand new bulb that i just bought today.  thanx for the compliments on the machine.  that mug on top is full of quarters!! '> |  
						| 
								|  |  
								|  |  Logged | 
 |  |  | 
	| 
			| 
					
						| MoonDawg | 
								|  | « Reply #4 on: August 12, 2006, 02:50:20 pm » |  | 
 
 A bad ballast will blow a new bulb, but you would see a bright flash first.  Pick up a new starter, that will make it flicker then go off.
 
 
 
 |  
						| 
								|  |  
								|  |  Logged | 
 
 Glen |  |  | 
	| 
			| 
					
						| Creighton | 
								|  | « Reply #5 on: August 12, 2006, 02:53:59 pm » |  | 
 
 *Edit* Glen was typing at the same time and did a better job :-) Does the wiring look ok?
 Creighton
 
 
 
 
 |  
						| 
								|  |  
								|  |  Logged | 
 |  |  | 
	|  | 
	|  | 
	|  | 
	| 
			| 
					
						| 
								Guest
 | 
								|  | « Reply #9 on: August 12, 2006, 06:40:13 pm » |  | 
 
 well that figures, i was born and raised in Batesville Indiana!  POP IT IS!!  I have not checked the wiring but i got a new starter and it still does not fire up...how can you test a ballast to see if it is any good? |  
						| 
								|  |  
								|  |  Logged | 
 |  |  | 
	|  |