SMC Discussion Areas
November 27, 2024, 04:30:50 am *
Welcome, Guest. Please login or register.

Login with username, password and session length
News:
 
   Home   Help Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: WD12 Compressor  (Read 3393 times)
0 Members and 1 Guest are viewing this topic.
Marines27
Newbie
*
Offline Offline

Posts: 5


« on: September 28, 2017, 01:58:06 pm »

Greetings,

I have  WD12 with a type M thermostat. It has run without incident for 25 years. Recently, I noticed the beverages in the cooler were freezing as the compressor was not shutting off.  I unplugged the cooler, let it sit for a few hours then a day, with the same problem. When I plugged it back in the last time, the compressor does not start.  The evaporator fan runs so it is not a power supply nor a capacitor issue as I understand it.  I ran a conductivity test from the terminal board to all three terminal posts on the compressor and that checked good.  I manually adjusted the thermostat with no success.
.
Logged
johnieG
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 5396


This is fine...everythings going to be OK....


WWW
« Reply #1 on: October 01, 2017, 12:15:12 pm »

Sounds like it’s time for a new thermostat, yours seems to be sticking closed ( freezing bottles) and now it’s stuck open.
Logged

Spoon-feeding Newbies since 2001...Wink
Yeah..220,221 whatever it takes.
Remember, all it needs is a shot of Freon!
The Vendo V-83 is the '59 Edsel of the coke machine world. ;p
Spray painting does NOT restore a compressor
11 is louder than 10...
"Hope" is good, but it's not an action plan.
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.15 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!