Looking for flat rivets (on both sides) for re-attaching hinges on slider lid

[brasskey]

The lid on my slider was attached to the hinges by what I assume is some type of rivet.  Does anyone know what these are called and if I can find them somewhere?  The rivet head on the top side is about 3/8" and the rivet head on the bottom side is about 1/4". There's about 1/8" between the heads of the rivets.  Below are a few pictures and a drawing of the rivet.

[MoonDawg]

      You should find what you need on this page.

       http://www.hansonrivet.com/w02.htm 

[mznb1u]

Rivetting good information Glen!

  Tim

You will have to excuse me, I just spent an hour and a half shoveling heavy wet snow off of my driveway!

[Slapshot42]

Here is a set from SJW.

http://sodajerkworks.com/index.php?page=shop.product_details&flypage=flypage_images.tpl&product_id=917&category_id=70&option=com_virtuemart&Itemid=27/


It looks like they only have 1 of the 2 pieces you would need to set the rivet??

I have been looking for them as well..let me know what you do. I just had a slider lid resurfaced, but still need to put the hinges back on.

[brasskey]

      You should find what you need on this page.

       http://www.hansonrivet.com/w02.htm 

Thank you. I'll will give them a call

Here is a set from SJW.

http://sodajerkworks.com/index.php?page=shop.product_details&flypage=flypage_images.tpl&product_id=917&category_id=70&option=com_virtuemart&Itemid=27/


It looks like they only have 1 of the 2 pieces you would need to set the rivet??

I have been looking for them as well..let me know what you do. I just had a slider lid resurfaced, but still need to put the hinges back on.

I'll let you know what I find out.

[Marvin]

Not the size you are needing, but I have been wanting to get one of these for some soda and pinball stuff.

http://www.pinrestore.com/Riveting.html

Marvin

[brasskey]

I also meant to ask, how were original DP porcelain signs attached to machines?  I've seen truss head slotted screws (1st picture), pop rivets (2nd picture) and truss head tubular rivets (like on the lid hinges pictured above).  What's the preferred method for restorers?

[kbareit]

Don't know if this will help. It's pics of the rivets on my new lid. They are the hollow rollover version compared to the solid hammered originals.

[brasskey]

Don't know if this will help. It's pics of the rivets on my new lid. They are the hollow rollover version compared to the solid hammered originals.

I think those look great Ken. Did you install them yourself?

[kbareit]

No, they came already installed on the lid. I got it from Funtronics maybe Rod can help you out finding the right ones.