1. Lid liner gasket - on the three outer edges of each lid half, is the gasket supposed to be a continuous piece, or does it get cut to length for each side? If cut, I'm guessing the long edge goes to the outer edge (sides) of the lid (as opposed to the short sides going all the way to the front edge)? Does anyone have a pic showing what this should look like?
2. My cooler did not have a drip pan underneath when I got it - what does it look like? Dimensions or pic?, and where did it mount?
I am redoing a WE-6 which has the same body of the Wd-12. My gasket was one long continual piece, but I dont think it matters if it was cut at the corners. You can order this replacement from Funtronics or Soda Jerk Works.
The drip pan is just a think piece of galvanized metal. I had a new one created and can measure the length for you. You'll have to figure how how to shape the ends though so it will fit in the cooler.