s.s. bezel on ideal slider

[r500]

Has anyone removed the stainless steel bezel on a ideal slider and if so how did you get it off

[Slider-Bob]

Do you mean on the coin box?

[MoonDawg]

        If you mean the SS trim across the front / top...........no! It is welded on.

[Pat Pixley]

Are you talking about the stainless steel piece right in front of the lid ?  If that is what your talking about  then yes
(see Attached photo) 

[r500]

The  S.S. across the front at the top is it only welded where the screw holes are?

[Pat Pixley]

The few that I've played with were not welded in just bolted in.

[cohammer]

are you sure they are not rivet's

[Funtronics]

We sell new ones that go right over top the old ones, and are held in with the screws that hold your rubber in. I think the originals are welded in and would be very hard to get off. You can go to our web sight www.fun-tronicsllc.com and check them out under the Ideal 55 section.

[SIGNGUY]

I had a old shell of a slider cooler they me and my body guy decided to see how hard it would be to dismantle.. and lets just say.. DoN"T you'll create more of a headache and mess trying to remove it and then trying to weld in a new peice... it is welded in in many places and you littlerly have to cut it outand it hacks up the body..
use the one that funtroncs sells , it's easy and looks great!

[Slider-Bob]

I currently have an Ideal 55 Pepsi slider that I'm parting out, and the 2 foot long piece at the top/front came right out.  

It was not welded on, and was easily removed.