SMC Discussion Areas
December 03, 2024, 12:30:28 pm *
Welcome, Guest. Please login or register.

Login with username, password and session length
News:
 
   Home   Help Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Coke machine not working???  (Read 8531 times)
0 Members and 1 Guest are viewing this topic.
coop6008
Guest
« on: June 24, 2010, 03:23:28 pm »

I was given this coke machine and every time I plug it in it throws a breaker in my homes fuse box. Can anyone help?
Logged
pepsi-perk
10 Cent Member
***
Offline Offline

Posts: 200


« Reply #1 on: June 24, 2010, 05:02:04 pm »

Trace all wire harnesses for brittle insulation and possible shorts.
Logged
coop6008
Guest
« Reply #2 on: June 24, 2010, 05:24:50 pm »

I'll check the wiring and see what I find. Thanks for the advice.
Logged
bubba
Soda Jerks
*****
Offline Offline

Posts: 3021



« Reply #3 on: June 24, 2010, 08:14:41 pm »

where are you located?
Logged

Ken

V-63 -Bottles
2-Cavalier USS-64
VMC ST56B Royal Crown - being built
Vendo HA56C Coke
2-V63C DP
V63C Coke
U-Select-It 5cent candybar machine
tkaz
Soda Jerks
*****
Offline Offline

Posts: 1900

tkaz


WWW
« Reply #4 on: June 24, 2010, 08:39:07 pm »

One thing to try is to turn the thermostat to the off position, then try plugging it in.  This can isolate a few different circuits, specifically the compressor and lower fan unit.
Logged

coop6008
Guest
« Reply #5 on: June 24, 2010, 08:54:00 pm »

I'll try these suggestions this weekend and hopefully I can fix it. Thanks for everyones input. I am located in Florence, Ms. About 10 minutes south of Jackson.
Logged
johnieG
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 5397


This is fine...everythings going to be OK....


WWW
« Reply #6 on: June 24, 2010, 10:12:06 pm »

was it working before? ( or did it ever work would be the better question) as suggested, you can trun the thermostat to the off position ( fully anti-clockwise/left) or some compressors have a plug on a what looks like a short little extension cord that plugs into the main wiring harness socket, you can also just unplug it at that point to help isolate the trouble, also if that doesn't work, you can unplug the coinmech too. next I'd disconnect the light-up sign's harness ( a bad ballast will cause lots of trouble)

I was wondering is you circuit breaker for that plug a standard 15/20 amp type or is it a GFI type?
Logged

Spoon-feeding Newbies since 2001...Wink
Yeah..220,221 whatever it takes.
Remember, all it needs is a shot of Freon!
The Vendo V-83 is the '59 Edsel of the coke machine world. ;p
Spray painting does NOT restore a compressor
11 is louder than 10...
"Hope" is good, but it's not an action plan.
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.15 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!