Should I part out a Stoner 11 pull?

[vendo39]

I know where I can get a Stoner 11 pull for about $200.  I really don’t want a 11 pull so I was thinking of parting it out as I would like the coin mech and related parts and I could use the pulls and some of the gum wheel parts.  I can’t make up my mind as I’m not sure it’s worth it for the few pieces I want. 

Does anyone else need anything if I part this out?  I think a lot of the vending parts are the same as the 8 pulls and maybe the Jrs.

Curtis, do the parts interchange?

Thanks

[memorylane]

The coin mec you should be able to get $75.00 to $125.00 The knobs are worth 15.00 to 20.00 each if in good condition. The Gum Wheel alone should be worth $45.00 + shelves might not be the same on alot of the Stoners the notch in the back is smaller but $75.00 + for all the shelves. The rods are worth $100.00 + with the springs Part out the rest $

[vendo39]

The rods are worth $100.00 + with the springs Part out the rest $

Thanks Curtis!    By the rods do you mean the rods in the back?

Thanks

[memorylane]

Yes the ones that hold the shelves. The springs are very hard to find if you need them but keep them on the rods. Remove from the bottom up. All must be in the down position to start removing them.

[sodaworks]

I'm short one candy gate shelf. I need the one that goes on the very bottom.