Can a v63 cooling system?

[choice120]

Be used in a v56 squaretop. The lines on the 63 run up the right side is it hard to switch them to the left. Also is everything else the same. Thanks

[collecture]

If you have to use the 63, then I'd just drill new holes for the line cover and leave the lines how they are. Just do a 'dry fit' and make sure that the lines do not interfere with the stack or anything.

[johnieG]

I've had success transplanting V63 systems into V56 square-cornered machines by simply "flipping" the deck around 180-degrees & aligning the evaportator lines to the opposite side of the chassis. 

[choice120]

I will give it a try. When you say flip 180 degrees do you mean turning the whole lower deck 180 to the right or left so lines are lined up on the left side. thanks I am up to 3 machines nowwith this addiction. The main door is pretty shot on my 63 so I am going to part out the door and look for a good one. Thanks again

[johnieG]

Yes, flip the lower compressor deck left to right, then you may have to carefully relocate the cooling lines over the top of the deck & then they should line up to the correct side of the chassis.

[coke_and_stuff]

Ive got a good tested V56 unit i'd sell very reasonable.

Joey