SMC Discussion Areas
November 27, 2024, 09:57:31 am *
Welcome, Guest. Please login or register.

Login with username, password and session length
News:
 
   Home   Help Login Register  
SMC Discussion Areas > Soda Machines, Coolers & Dispensers > Pre 60's Machines & Coolers (Moderators: johnieG, Jim) > Need help venting!
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: Need help venting!  (Read 2932 times)
0 Members and 1 Guest are viewing this topic.
G.Pope
Guest
« on: September 18, 2008, 11:20:27 pm »
Hey,
I have a machine that has a couple of crooked vent splines on the bottom of the machine where the compressor is. Does anyone have a sure fire way of straightening those little buggers? One is pretty crooked or should I say wavy. I am in the restoration process, so anything goes.
Thanks
Logged
sodaworks
Soda Jerks
*****
Offline Offline

Posts: 3532
« Reply #1 on: September 18, 2008, 11:26:00 pm »
Hammer and dolly and patience.
Logged
TERRY@SODAWORKS RESTORATIONS
Lots of Round Top machines
Buy-Sell-Trade-Restorations
G.Pope
Guest
« Reply #2 on: September 18, 2008, 11:37:14 pm »
How do you hammer and dolly when there are 20 in a row and there is 1/4" between each one? Do you cut a single one out, hammer it and then weld it back in? Can you explain in a little more detail?
Thanks
Logged
sodaworks
Soda Jerks
*****
Offline Offline

Posts: 3532
« Reply #3 on: September 21, 2008, 10:18:43 am »
responed to your email.
Logged
TERRY@SODAWORKS RESTORATIONS
Lots of Round Top machines
Buy-Sell-Trade-Restorations
Pages: [1]   Go Up
  Print  
« previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.15 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!