Interior decorating

[Skeleton Man]

Hi guys,

I checked at Home depot and they carry rustoleum hammer spray, which I want to use inside inside my Cav CSS-64. I'm thinking liner and shelves definately for painting, but wondering if it's safe to spray parts of the bottle stack ?

Few more questions on cleaning/painting:

1) How do I remove the bottle stack ? (and will this require an extra pair of hands?)
2) What do you guys use to sit the compressor, etc on when removing it ? (last time I had everything balanced on a chair, but scared of breaking lines)
3) How do I get the coils (evap/cond) looking all shiney and new, and/or can I paint them ? (without sandblasting)
4) Is there a technique to applying the rustoleum paint ? I was thinking of the spray bombs, but apparantly it can be bought by the gallon and rolled on too ?
5) Is there anything I should worry about when pressure washing the machine ? Do I need to remove anything other than the coin mech ?

Any advice on cleaning/painting is welcomed. I'm not re-painting the outside just yet, I might get it done later professionly coz I don't have the equipment. There are no big hunks of paint missing, just lots of scratches, some of them look deep.

Chris

[MoonDawg]

     Remove the shelves, unhook the wires at the bottom and remove the 2 bolts
at the top of the stack and it will lift out easily.
     Build a simple little platform to set the evaporator just above the compressor
to make it easy to paint and re-wire, Sandpaper and steel wool makes the
copper lines look new, silver paint for the condenser.
     Hammer spray the shelves and inside of the bottle stack.

[collecture]

One thing I do when washing out the interior is to reinstall the screws in the respective holes to keep water out of the insulation area.

[Pat Pixley]

I like Copper bright to clean up the lines and like Glen I had a stand
made.
I also use a wire wheel to clean off the rust then hand sand
some of the stuff.
And new screws and bolts.   What I use when I bolt the compressor
down is some Chrome bolts , washers & nuts  And it sets things off just nice

[MoonDawg]

     Remove the shelves, unhook the wires at the bottom and remove the 2 bolts
at the top of the stack and it will lift out easily.
     Build a simple little platform to set the evaporator just above the compressor
to make it easy to paint and re-wire,you can then even screw it down to prevent
it from falling off and kinking the tubes. Sandpaper and steel wool makes the
copper lines look new, silver paint for the condenser.
     Hammer spray the shelves and inside of the bottle stack.