7up Ideal 55

[Pat Pixley]

Is the Brush finish look ok ?

[zadd]

If it looks good on your machine its fine with me. I was going to get a new lid for the machine and just polish the stainless rolled trim piece, so if you think it will look good together beggar's can't be choosy. The one I have has small dents on it and I want everything to look new. Let me know thanks.

[zadd]

Where can I get a new piece of stainless rolled ? I can't find the small half round molding so I guess I will look in to getting a new piece without the lower trim holes . Any Ideas ? 

[Kilroy]

I think Steve @ Soda Jerk Works carries it

[MoonDawg]

    I will be parting this machine out soon. Is this trim something you can use?

[Pat Pixley]

Glen, I think the 85 trim is longer than the 55 trim?

[zadd]

I hate to admit it but I messed up when I painted the machine. I was looking at my photo's I took before restoring it and remembered it had a green triangle around the 7up . Back to the paint shop next week. Should be an easy fix though . Just sand down the center section of the machine and lay out the green and re clear. 

[MoonDawg]

      I'm thinking some green vinyl striping tape would achieve the same look.

[zadd]

I had to paint them on . Did it today, will post pic later .