V 63 part needed

[Malinut]

Where can I get the parts to replace a hacked up Jones block?

The block may be ok,  I think the wires going into the block need to be removed, recrimped and reinserted.

Thanks in advance,

Frank

[BryanH]

Frank - search the forums for "jones plug".  At one time someone on the board had a supply of shrouds.  I also have this parts supplier bookmarked.  Never ordered from them... but believe someone here on the boards may have.

[Malinut]

Thanks Bryan,

I was hoping not to replace and rewire the entire block.

I just want to remove the 1 and 3 wires from the block and attach new connectors ( they look bad, almost severed at where they were crimped).

I really would like a few of the connections that go inside the block.

When I put coins in a known good coin mech, it does not trip the relay.  The free vend switch (wired under the block) is working fine.

Frank

[MoonDawg]

You only need a few 1/4" female spade connectors. They are available at auto parts or electronics stores.