C-51 parts needed

[dprat1]

Greetings all,
For my Cavalier C-51, I am searching for an original drip jar and the counter weighted dump drain for this. I have the drain but did something stupid while trying to restore and I think is beyond repair '>  I broke the cast around the hinge while trying to remove the pin. Didn't think that one out very well first '>
doug

[Jim]

Doug,

I think in most cases people use a glass jar that fits best...
Attempting to locate an original jar is going to be out of the question especially since any jar was used most of the time back then...
Ashame the hindge is broken; that may need some JB Weld...

[MCarter]

Prat,

I might have an extra Dump Drain. I can look if you want. I used a Glass Jar that square on the bottom. I have a few extra too.
Matt

[dprat1]

Thanks for the replies. Jim, I considered a JB fix but the broken off piece is so small I do not think it would hold for long ,if at all. Matt, if you have a dump valve and square jar I would be interested...and cost. I could probably pick them up since I am in Bloomington occasionally. Feel free to e-mail me.
Thanks,
doug

[kstt]

Lots of spaghetti sauce jars are just about right.

[dprat1]

Still looking for a dump valve,,,,,no luck so far '>
doug

[loman4ec]

Can you take a pic of it I think I have one. It is on my 96 but it should be the same. If you think it will work you can have it.
Josh

[dprat1]

Josh,
A couple pic's of drain valve. Appreciate the help.
doug

[loman4ec]

Mine is slightly different but you can have it if you want to try it. PM me your address if you want it.
Josh

[MoonDawg]

Looks the same to me Josh........the tube just pulls out!