SMC Discussion Areas
November 23, 2024, 12:50:06 pm *
Welcome, Guest. Please login or register.

Login with username, password and session length
News:
 
   Home   Help Login Register  
SMC Discussion Areas > Soda Machines, Coolers & Dispensers > Pre 60's Machines & Coolers (Moderators: johnieG, Jim) > Jacobs 26 Handle, does anyone know how to Remove it?
Pages: 1 [2]  All   Go Down
« previous next »
  Print  
Author Topic: Jacobs 26 Handle, does anyone know how to Remove it?  (Read 6592 times)
0 Members and 1 Guest are viewing this topic.
MoonDawg
Soda Jerks
*****
Offline Offline

Posts: 6227
« Reply #10 on: October 17, 2015, 04:55:55 pm »
      Looks like it is just pressed in and secured with the 2 fasteners.
      Can you make a tool similar to a wheel puller?
      Have it hooked to the back of the housing, tighting the bolt pushes the coin mech shaft through the handle body.
Logged
Glen
Creighton
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 4938
« Reply #11 on: October 19, 2015, 04:02:30 am »
Well I'd spray with PB Blaster, let that soak 48hrs tap with a hammer. Repeat. It will break loose at some point.
Best of luck!!
Creighton
Logged
SIGNGUY
Soda Jerks
*****
Offline Offline

Posts: 5442


Collector of Ol Smoothie Rootbeer


WWW
« Reply #12 on: October 19, 2015, 09:03:02 am »
Yeah pretty sure it's just stuck... I think I used some heat on the shaft part.. scorched the paint but no biggy as was being restored.

the handle I think is pot metal so don't put heat on that..  heat, tap, repeat..
Logged
Soda Machine Enthusiast since 1996!
Creighton
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 4938
« Reply #13 on: October 20, 2015, 01:42:13 am »
If the handle is pot metal I would be careful heating the metal shaft. Too hot and it could expand enough to break the pot metal.
Creighton
Logged
Pages: 1 [2]  All   Go Up
  Print  
« previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.15 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!