Looking for a couple small pieces for my 55 Pepsi Slider

[66GTO]

Hello All,

I'm looking for a couple small pieces to complete my Ideal 55 Pepsi slider.  I'm looking for an original thermostat knob (see attached pic).

I'm also looking for a Vin # tag that mounts on side of the cooler by the coin mech.  The hole spacing is about 1.75".  

[MoonDawg]

      Check with Bob Slider........he has everything you need! 

[Slider-Bob]

Thanks for the plug Glen!

Yes Duane, I have a NOS original thermostat knob. 

Regarding the vin # tag on the left side, if it's this little brass tag that is oval a couple inches in length and says something like G2375, it is usually found more often on 35's, not 55's.

The 55 vin # tag I'm thinking of is about the size of a credit card and is usually located on the right side below the loading door. See pic attached.

Give me a couple days, and I'll shoot you some pics of what I have.  Thanks.

[Slider-Bob]

Here's the 35 tag from JohnieG's O-So Grape. Hard to see at the bottom. I have one of these tags available, just not the actual pic handy.

[66GTO]

Thanks for the plug Glen!

Yes Duane, I have a NOS original thermostat knob.  

Regarding the vin # tag on the left side, if it's this little brass tag that is oval a couple inches in length and says something like G2375, it is usually found more often on 35's, not 55's.

The 55 vin # tag I'm thinking of is about the size of a credit card and is usually located on the right side below the loading door. See pic attached.

Give me a couple days, and I'll shoot you some pics of what I have.  Thanks.

Thanks for the fast reply.  It is the smaller brass tag I believe.  The spacing between holes is 1 5/8" apart (disregard my earlier measurement) and there are only two holes in the body.  Definitely not the credit card sized one.  I look forward to hearing from you.