Westinghouse WC-60 Locxking Bar Assembly Needed ! ! !

[Jim]

Hello,

Looking to see if I can locate a locking bar assembly for the mentioned machine, Westinghouse WC-60
I have the opportunity to purchase for $300 but missing locking bar...
Any direction appreciated in advance!
Jim

[johnieG]

I believe a WC78 locking bar will also fit the WC60 as well, (the actual coindoor door will not however) so maybe it will double your chances of locating one.

[dr galaga]

If the coin door is the same as a WB102 (mine looks like a WC), I can set you up. I'll be parting this machine out.

[Jim]

I would have to agree w/ Johnie in that the same locking bar any have been utilized on both WC/WD-60 & WC/WD-78
For what it may be worth, the measurement between the two locking bar support brackets welded to the coin door are approx. 15 5/8" apart...
I'm going to see if I have a manual and research a little further before I decide to purchase...
Thanks for the replies too! Anyone else have a parts machine WC/WD-60...?

[Jim]

Anyone able to confirm whether or not you have a locking bar...?
Haven't committed  to the purchase until I have a good lead on one...
Thanks ! ! !

[dr galaga]

I had a chance to get to my parents place this morning. Looks like what I have should work for you Jim (brackets are about 15 5/8" apart). I emailed you a picture.

[Jim]

Thanks Brent ! ! !
PM with a price; I have a call into the seller to see if $250 - $275 will land me the machine...