I made a new 2 Prong Plug out of a basic 18-2 cord. I crimped on new ring terminals and put them back on the terminal box. I have wire "ends" that go to the fan motor. And I have wire "ends" going to the thermostat. I plugged the new 2 prong cord into a extension cord and into the wall and I hear the compressor kick on. Of course the fan, motor and the thermostat are not wired yet. ( At this point the new harness is out of the equation) So, I need to tie the new harness in to get power to the thermostat, fan motor, and terminal box which should be 6 total wires, in sets of 2.
How do I tie in my harness to to go to my thermostat, compressor fan, and the terminal box. I bought "spade" terminals to hopefully cut the ends off the new hardness and crimp on the terminals, than crimp on the opposite terminals to the existing thermostat, and fan wires? That way I can connect back up to the existing wire with the new harness.
I think the most difficult thing is trying to figure out what wire is what on the new harness