SMC Discussion Areas
November 23, 2024, 07:45:04 am
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News
:
Home
Help
Login
Register
SMC Discussion Areas
>
Soda Machines, Coolers & Dispensers
>
Post 60's Machines & Coolers
(Moderators:
johnieG
,
Jim
) >
Lacross burning smell
Pages:
1
[
2
]
All
Go Down
« previous
next »
Print
Author
Topic: Lacross burning smell (Read 9369 times)
0 Members and 1 Guest are viewing this topic.
scalebowler
Soda Jerks
Offline
Posts: 1254
Re: Lacross burning smell
«
Reply #10 on:
August 11, 2011, 12:43:50 am »
I would try to replace the wiring inside but there is no wiring diagram in the machine so I have no idea what goes where. I guess I could tag each wire and tag the terminal on the switches that they go to and make a new wiring harness.
«
Last Edit: August 11, 2011, 12:48:31 am by scalebowler
»
Logged
scalebowler
Soda Jerks
Offline
Posts: 1254
Re: Lacross burning smell
«
Reply #11 on:
August 11, 2011, 09:05:35 pm »
Ok I looked at it today and found that the coin mech stopped working because the fuse on the logic board blew and I believe that my vending problems may have been caused from when I slid the vending gate back in the wiring harness had fallen back a little bit and was pulling on the wires so when it was slid back in the connector slid off of one of the switch terminals and I think that was telling it to dump out a can automatically. Going in tomorrow with my screwed up coin mech that dumps out all the coins to test to see if the vending problem has been fixed. I do think we might need a new coin mech though or at least a new logic board.
Logged
scalebowler
Soda Jerks
Offline
Posts: 1254
Re: Lacross burning smell
«
Reply #12 on:
August 29, 2011, 12:57:28 am »
Ok I got the coin mech back up and working and since we decided to just forget about it and run on 3 selections instead of 4 I swapped out the vending gate that I had to modify to get the origional solenoid to fit with the other vending gate and then hooke everything back up and you know what? IT WORKED!!!! All 4 selections are now up and running! I found out that the problem I was having was caused by a stupid wire connector that when I slid the vend gate back into the machine it pulled on the connector and would unhook it and when I swapped out the gates I ended bending the terminal a lot more and pulled the wiring harness out a little bit so I had more slack in the wires and it is all working.
Logged
indymanjoe
Newbie
Offline
Posts: 40
Re: Lacross burning smell
«
Reply #13 on:
August 29, 2011, 06:34:08 am »
nice to hear ya got it running again!and what the problem was.
Logged
Pages:
1
[
2
]
All
Go Up
Print
« previous
next »
Jump to:
Please select a destination:
-----------------------------
The Coin Return
-----------------------------
=> Soda-Machines.Com News
=> Other Coin-Op's
=> General Chit Chat
=> Estimated Values
=> Tutorials & Tips
-----------------------------
Soda Machines, Coolers & Dispensers
-----------------------------
=> Pre 60's Machines & Coolers
=> Post 60's Machines & Coolers
=> Picnic Coolers
=> Syrup Dispensers
-----------------------------
Trouble-Shooting
-----------------------------
=> Coin Mechanisms
=> Refrigeration
=> Vending Mechanisms
-----------------------------
Restorations
-----------------------------
=> General
=> Refinishing
-----------------------------
The Vending Rack
-----------------------------
=> Swap Meet Area
Loading...