Stoner "Fresh Gum" Mounting Brackets

[Chedki]

I have one of the Stoner Fresh Gum machines. I am wondering if mounting brackets were made for them to be installed on the wall rather than onto the side of another Stoner machine. I'd like to display it on the wall if there are brackets for them.

[Jim]

After checking with two fabricators, I ruled one out as I never dealt with them before and their price was high to me. They quoted me $38 for fabricating one large bracket and one small inside bracket...
The other fabricator I have dealt with before and quoted me $28 for the same brackets, lg and small brackets. So, a complete set for upper and lower brackets w/ inside brackets would be $56 + shipping.
Additionally, the two large brackets will be powder coated gloss black and the small interior brackets will be powder coated in silver. I will also include hardware and height measurements for mounting holes provided Curtis gets back with me...

I may be able to get a slightly lower price depending on the quantity ordered...
If this seems acceptable, anyone interested, please Contact Me with any questions/concerns and let me know who would like to order a set...?


And lastly, Chedki, you can easily mount the Stoner "Fresh Gum" machine to the wall utilizing heavy-duty anchors or better yet, at least locate one wall stud and use this for one set of mounting screws. For the other side, use heavy-duty anchors anyway...

[MCarter]

I will take a set. I have a junior and a gum machine. Not sure what i need.

[collecture]

Message sent.

[Jim]

It's been a few days and as it stands, I have 4 interested...
Hopefully, I'll be talking with the fabricator tomorrow and see how things went since he was supposed to make a set... I'm hoping to get a real number of bracket sets needed so I can pin down an actual/final price...
So anyone else considering to purchase a bracket set, let me know because I will not be ordering too many extras!

[BrianB]

Jim, count me in for a set as well! Thanks for doing all of the research and legwork on getting these reproduced!

[Eric]

Jim did you get my PM for Neil? I know he wants a set.

[Jim]

Jim did you get my PM for Neil? I know he wants a set.

Spoke with Neil yesterday and he wants a set as well

[Jim]

Update for those who sent payment; I stopped by the fabricator today, but he informed me that the large external brackets will be done next week...
The inside backing plates have been produced and powder coated, so once I receive the outside bracket, they'll be powder coated in gloss black as soon as possible!

[Jim]

Here's a few photos of the brackets I reproduced...
I BIG Thank You goes out to Larry for sharing his brackets making this possible ! ! !
The last photo shows the Stoner "Fresh Gum" Vendor just being held in position w/ brackets...