Anyone parting out a V-80?

[glenp87]

Is anyone serious about parting out a V-80.....I am looking for the entire molded bottle chute and flapper door (on main door); coin box,cap box;Sold Out Lever,pin & spring.

The sold out lever is circled in the picture......the back molded bottle chute is in the lower center of the picture (held on by six screws on back and two on the door frame).

Thanks,

Glen

[collecture]

Would this work?? I know they are not identical.

http://cgi.ebay.com/Vendo-Vendorlator-144SA-Bottle-Sensors-and-Flippers-/270620968050?pt=LH_DefaultDomain_0

[loman4ec]

I think it should work.

[glenp87]

Thanks for the ideas....I will think about it....I have the original bracket and working switch......

Glen

[loman4ec]

Can you make something to work? Or even still since it is not being used in the field it s really not needed why not just use it without it and not worry about it.

[glenp87]

That is where I am right now,,,,the machine works without the lever (just will not alert when low)....I am in no hurry....I do know a few have mentioned they may be parting out their V-80's...so I wanted to ensure they knew I was still looking for some parts....if someone could get me really detailed pictures of the lever, pin and spring and measurements, I would make one.

Glen