Rust

[scalebowler]

I think the screws in my machine are sheet metal screws. Sheet metal screws have the sharp point and that star shaped washer thing on them on them right and machine screws look like bolts? Just checking.

[rayg]

Yes, that's correct, you should be good to go. post pics when you are done .

Good Luck!

collecture,  welded  nut on the back side of the liner......that makes sense, since the liner metal is too thin to tap... thanks sharing your knowledge .....I alway hate to learn something the hard way LOL

Ray

[scalebowler]

Yes, that's correct, you should be good to go. post pics when you are done .

Good Luck!

collecture,  welded  nut on the back side of the liner......that makes sense, since the liner metal is too thin to tap... thanks sharing your knowledge .....I alway hate to learn something the hard way LOL

Ray

Thanks! The stuff just came by ups about an hour ago so I might be trying this out this weekend. I will be sure to post some pictures of it. Get a before and after shot as well.

[loman4ec]

The easiest way is to build up some JB Weld on the liner. It gets hard enough to drill and tap. It even says it on the box. I have done it before and it works great. If you don't have a welder or just don't want to use it the JB Weld is easy and cheap.