Ok guys, I have a big one for ya. I am rebuilding my v39 refrigeration system and have bought this compressor:
http://www.grainger.com/Grainger/items/4MG93 This one is a 1007BTU and the one I removed was a 1075
I am going to reuse the original evaporator and condenser, but the cap tube and the return line are going to both need replacement due to being brittle from vibration hardening and the machine sitting in the weather for who knows how long.
Here are my questions (please help if you can)
1. Since I am switching the system from R-12 to 134A, the capillary tube length and internal diameter go out the window. So, how long and what internal diameter Cap tube do I need to use for the rebuild?
2. I have 1/4"OD 3/16" ID refrigeration tubing in my shop I could use for the return line, but the original was about 5/16" OD and 7/32" ID. How much difference will this make in the operation if any? If its a big deal, I have to go to Johnstone to get the cap tube anyway and can get the same size as original.
3. How in the world do they get the cap tube soldered to the side of the return line and make it look so good? <<< more rhetorical, but if you know please share!
4. The compressor came with a "supply bag" that looked like a generic "throw in the box" kit that included a run capacitor. the instruction/specification sheet that came with it is about as vague as I have ever seen. There are two wiring diagrams and one shows the compressor with the cap, and one shows it without it. The drawing with it is listed as RSCR, and the one without it is listed as RSIR. How do I know which application to use??
5. On the bottom side of the evaporator, just before a 90 degree bend leading up into it, the cap tube ends into what looks like an in-line filter about 2 1/2" long by about 3/4" round. Is this a filter I need to remove or is it an expansion chamber of sorts? It just looks suspect.
Thanks in advance for any help, Tracy
