SMC Discussion Areas
November 23, 2024, 12:19:19 am
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News
:
Home
Help
Login
Register
SMC Discussion Areas
>
Trouble-Shooting
>
Refrigeration
(Moderators:
johnieG
,
Jim
) >
LaCrosse 90 bottle machine
Pages: [
1
]
Go Down
« previous
next »
Print
Author
Topic: LaCrosse 90 bottle machine (Read 2292 times)
0 Members and 1 Guest are viewing this topic.
Alan
Newbie
Offline
Posts: 1
LaCrosse 90 bottle machine
«
on:
September 25, 2016, 10:58:05 am »
I have a LaCrosse 90 Pepsi machine. I recently had to replace the condenser fan and had it checked for freon. It was very low and takes r 12 that is not available. I had the r 12 vacuumed out and replaced it with Red Tek R12a. I then watched it cycle through several times. It is half full of bottled water. The thermostat setting is on 1.5. It does cool and the fans are running. The compressor is shutting off at 35.5 degrees and turning back on at 45 degrees. The temp of the water is 37 degrees. It runs for 45 minutes and then cycles off for 35 minutes. The door gaskets are good and not leaking. Compressor sounds normal. One copper line is showing frost from the bottom of the cooler going down about eight inches and there is no frost on the evaporator coil. Is it normal to run this long?
Logged
Pages: [
1
]
Go Up
Print
« previous
next »
Jump to:
Please select a destination:
-----------------------------
The Coin Return
-----------------------------
=> Soda-Machines.Com News
=> Other Coin-Op's
=> General Chit Chat
=> Estimated Values
=> Tutorials & Tips
-----------------------------
Soda Machines, Coolers & Dispensers
-----------------------------
=> Pre 60's Machines & Coolers
=> Post 60's Machines & Coolers
=> Picnic Coolers
=> Syrup Dispensers
-----------------------------
Trouble-Shooting
-----------------------------
=> Coin Mechanisms
=> Refrigeration
=> Vending Mechanisms
-----------------------------
Restorations
-----------------------------
=> General
=> Refinishing
-----------------------------
The Vending Rack
-----------------------------
=> Swap Meet Area
Loading...