SMC Discussion Areas

Trouble-Shooting => Coin Mechanisms => Topic started by: sjt1803 on September 04, 2018, 04:53:31 pm



Title: Coinco S75-9800A coin changer
Post by: sjt1803 on September 04, 2018, 04:53:31 pm
Quick Question, for those out there familiar with these coin changers

Is it normal operation for one or more of the lockout solenoids to be active during standby operation.

Does it have any effect on normal operation if there are No change coins present?


I did find an interesting thing when it came to the coin switches, normal operation is for the switches to be on in standby.











Title: Re: Coinco S75-9800A coin changer
Post by: johnieG on September 04, 2018, 08:42:17 pm
Quick Question, for those out there familiar with these coin changers

Is it normal operation for one or more of the lockout solenoids to be active during standby operation.

Does it have any effect on normal operation if there are No change coins present?


I did find an interesting thing when it came to the coin switches, normal operation is for the switches to be on in standby.


Yes... no change means the mech will only accept exact change, example for a 10-cent purchase you'd have to insert 2-nickels or 1-dime, the mech will reject a quarter in this example.
also note that both CREMs as they are called are normally held in when all is right insofar as the mech is concerned IE; sufficient change in the tubes & the bottle stacks vend switch is in the "ready to vend " position. that means that it's ready to vend & not sold out or in a current vending cycle or stuck in the middle of a cycle ( such as a bottle hasn't been delivered or removed from the machined yet















Title: Re: Coinco S75-9800A coin changer
Post by: sjt1803 on September 04, 2018, 11:01:48 pm
Thanks for answering
It seemed right but I thought it strange to have coils powered continuous. (heat and current draw on the control bd)

So... If it's set for a dime, is there any situation when the coil(s) are not powered?

As far as a ready to vend switch, there isn't one. This coin changer is in  a VFA56
As far as I can see there is no way for the coin changer to determine the machine is ready to vend.

The only connection to the bottle stack is momentary power for the solenoid on it, when the machine is coined up.