SMC Discussion Areas

Soda Machines, Coolers & Dispensers => Pre 60's Machines & Coolers => Topic started by: vendo39 on September 24, 2009, 11:44:45 am



Title: V44 - Where does this little part go?
Post by: vendo39 on September 24, 2009, 11:44:45 am
Can anyone tell me where this little piece of sheetmetal goes? I can't remember. :down:  I know it fits inside the liner but I don't know where and if the holes point up or down.

Thanks

Brian


Title: Re: V44 - Where does this little part go?
Post by: collecture on September 24, 2009, 11:55:42 am
It goes in the bottom of the liner behind the evaporator - kind of a deflector of the cold air.
Check out page 19 (Cabinet Assembly-Figure 2) of the VMC-44 manual I submitted to the downloads section of the site.


Title: Re: V44 - Where does this little part go?
Post by: vendo39 on September 24, 2009, 04:09:14 pm
Thanks for reminding me!  :happydrinkers: :happydrinkers:

Your tip fixed the problem and all the parts fit correctly now!  I had forgotten the evaporator sits at an angle.

I don't know how I missed the drawing in the parts manual but I did!  Thanks for submitting it!