SMC Discussion Areas

I have a few original Bottle Door medallions from Vendo 81's that I'd like to get restored.. I have had a few decent ones that with a slight buffer have made look great, but have some that are a little rough, and wondering if anyone has perfected a technique to bring these back to life.. would like to keep the originals ,but know that repos are available too..

Short of adding like-material and sanding & polishing the only real way to get them clear and shiny is to remove material. Albeit a very small amount.

Here at work as part of my job, I do cross-sectioning of electronic components which involves potting, preparing components, cutting into them and then sanding & polishing to get a sample so clear that it can be viewed using a Scanning Electron Microscope or low/high-powered microscope with no visible scratches.

I'd be willing to take a look at one and see what could be done from a polishing standpoint.

        Many have cracks through them so they will not polish out but if the outside
can be brought smooth again, the inside can be sandplasted with a fine medium,
then painted

I have managed to bring a few back to life with some light polish and novus cleaner, but one has some marks on the face from someone else trying to polish it and it got too hot.. scarred it just a bit.. others have paint over them, and not sure what to use to remove paint without harming plastic?

Brian, PM your address I'll send you one to see if you think you can do something with it?..

Sounds good, PM sent.

I lucked out. The pepsi machine I got the plastic one for the sign was in mint condition. I tore it apart and cleaned it. Looked even better. Now if the rest of the machine would look as great. I also keep it in the garage out of the sun for no fading. As for the other machine I had and tore parts off of. no sign. So go figure. Only need one sign.

TTFN,

Josh