|
Title: Need help venting! Post by: G.Pope on September 18, 2008, 11:20:27 pm Hey,
I have a machine that has a couple of crooked vent splines on the bottom of the machine where the compressor is. Does anyone have a sure fire way of straightening those little buggers? One is pretty crooked or should I say wavy. I am in the restoration process, so anything goes. Thanks Title: Re: Need help venting! Post by: sodaworks on September 18, 2008, 11:26:00 pm Hammer and dolly and patience.
Title: Re: Need help venting! Post by: G.Pope on September 18, 2008, 11:37:14 pm How do you hammer and dolly when there are 20 in a row and there is 1/4" between each one? Do you cut a single one out, hammer it and then weld it back in? Can you explain in a little more detail?
Thanks Title: Re: Need help venting! Post by: sodaworks on September 21, 2008, 10:18:43 am responed to your email.
|