|
Title: dixie narco 320 compressor Post by: boilerman on September 14, 2008, 01:22:44 pm I picked up a dnbc 302/186-7 and it looks good but didn't cool. i replaces the capacitor but I did not get anything from compressor the fans run. what are the pinout on the compressor so I can check for continuity between run start and common make sure the internal overload isn't bad
any other ideas out there? thanks Title: Re: dixie narco 320 compressor Post by: boilerman on September 14, 2008, 05:04:30 pm It is an embraco compressor. I do not have open circuit on all three pinouts
X X X top two are good but bottom one is dead any ideas Title: Re: dixie narco 320 compressor Post by: johnieG on September 14, 2008, 05:51:57 pm Here is an example diagram
Title: Re: dixie narco 320 compressor Post by: boilerman on September 14, 2008, 06:55:56 pm I get the following
a-b 5.6 a-c OL b-c OL is my internal overload fried ? Title: Re: dixie narco 320 compressor Post by: globalcompressors on September 14, 2008, 07:05:38 pm There is not an internal overload on the Embraco compressor. If you have an open wind, on the run terminal, the bottom one, the compressor is a boat anchor. Time for a new one!
Eric Title: Re: dixie narco 320 compressor Post by: boilerman on September 14, 2008, 07:26:21 pm thanks
any idea what it would cost to change out the compressor on the deck? Title: Re: dixie narco 320 compressor Post by: globalcompressors on September 14, 2008, 08:55:50 pm Sure, give me a call. My toll free number is at the bottom. We have a couple of options
that we offer! Thanks, Eric Title: Re: dixie narco 320 compressor Post by: johnieG on September 15, 2008, 09:54:22 am There you go! ( Thanks Eric)
Title: Re: dixie narco 320 compressor Post by: globalcompressors on September 16, 2008, 11:09:25 pm Welcome... :smile:
|