|
Title: Help with shrinking metal Post by: G.Pope on July 20, 2008, 09:54:38 pm I have a few of the vent grates on the bottom of a vmc-81 that are a little distorted ( a little wave, no bends or kinks...just not straight enought) and need a little strinking. I have never done this and was wondering how you guys do this. I have a small MAP gas torch and a mig welder if either of these items help. The machine is down to metal so no problem with working on it.
Thanks Title: Re: Help with shrinking metal Post by: sodaworks on July 27, 2008, 06:34:20 pm I normally use a hammer and dolly for stretched louver vents.
|