|
Title: Aligning vend door? Post by: Slamking18 on September 12, 2007, 07:55:58 am I guess I have a USS-96 or at least that is the closest machine to what I have. The seal on the vend door is in very good condition and I dont see anywhere that it is sunk in. About a foot on the side opposite of the hinge and about 6 inches of the lower portion of the door does not hit the seal. The door is as out as it can be on the machine and I think my problem is that the hinge side of the door is holding it out causing this gap.. Do you guys have any ideas that I might be able to try? Right now, I have some foam tape on the door itself to hit the seal, but I only want this to be temporary. The seal looks good to me, as it is sticking out far so I am not sure what to try first...
Title: Re: Aligning vend door? Post by: aspbear on September 12, 2007, 10:05:10 am There are adjustment screws on the hinge part of the door. It sounds like the top is set different than the bottom but you can ususally adjust this out with the screws and moving the door back and forth...
Title: Re: Aligning vend door? Post by: Slamking18 on September 12, 2007, 11:48:08 am Yeah, there are adjustments on the hinges and right now both top and bottom are as far out as the slots will allow... I am almost considering slotting the hinge on the door side too so I can bring it out even more... your thoughts?
Title: Re: Aligning vend door? Post by: MoonDawg on September 12, 2007, 11:59:09 am Lift the gasket in it's low spot and bolster it up with sponge tape
Title: Re: Aligning vend door? Post by: Slamking18 on September 12, 2007, 12:53:19 pm I tried that also, but I dont think it is the seal that is low, I think the door is just not sitting right. The seal looks the same in the spots that are hitting the door as the spots that arent...
Title: Re: Aligning vend door? Post by: Creighton on September 12, 2007, 04:39:25 pm On my USS I had to shim this part to get the door to close correctly. Located on the bottom chasis opposite side of the hinges. There should be a roller on the main door that makes contact.
Creighton Title: Re: Aligning vend door? Post by: Slamking18 on September 12, 2007, 07:55:02 pm Hmmm.. I will look, but I dont think I have anything like that... I will keep you posted and I will get some pics of my door...
|