|
Title: V 63 part needed Post by: Malinut on June 20, 2007, 12:02:16 pm Where can I get the parts to replace a hacked up Jones block?
The block may be ok, I think the wires going into the block need to be removed, recrimped and reinserted. Thanks in advance, Frank Title: V 63 part needed Post by: BryanH on June 20, 2007, 04:25:01 pm Frank - search the forums for "jones plug". At one time someone on the board had a supply of shrouds. I also have this parts supplier bookmarked. Never ordered from them... but believe someone here on the boards may have.
Title: V 63 part needed Post by: Malinut on June 20, 2007, 08:58:28 pm Thanks Bryan,
I was hoping not to replace and rewire the entire block. I just want to remove the 1 and 3 wires from the block and attach new connectors ( they look bad, almost severed at where they were crimped). I really would like a few of the connections that go inside the block. When I put coins in a known good coin mech, it does not trip the relay. The free vend switch (wired under the block) is working fine. Frank Title: V 63 part needed Post by: MoonDawg on June 21, 2007, 10:56:15 am You only need a few 1/4" female spade connectors. They are available at auto parts or electronics stores.
|