Title: Crank handle backing plate
Post by: USMC Vet on May 27, 2007, 01:08:52 pm
Does anyone know what this might fit ? It would not fit my 81D,with large door. I have a small coin door and the bubble fits perfect in the opening in the coin door.
Title: Crank handle backing plate
Post by: collecture on May 27, 2007, 01:25:23 pm
Looks like a large door bezel - maybe a Westinghouse 42T?
Title: Crank handle backing plate
Post by: sodaworks on May 27, 2007, 06:59:59 pm
Tony,
Let me se if I have an extra one. If so it's yours. Give me a couple of days to look.
Let me se if I have an extra one. If so it's yours. Give me a couple of days to look.
Title: Crank handle backing plate
Post by: USMC Vet on May 27, 2007, 08:16:18 pm
Sounds good Terry. I 'll give you some $ for it. Thanks! Tony
Title: Crank handle backing plate
Post by: sodaworks on May 30, 2007, 09:41:33 am
Tony, The extra's that I have are all for the small door version. Can you post a couple of more photo's of your mech., coin door and alignment so that we can figure out what you have and what you need.
Title: Crank handle backing plate
Post by: MoonDawg on May 30, 2007, 10:06:20 am
I agree with Tom, this plate is off a Westinghouse, 42 / 96 or
square top 44.
square top 44.
Title: Crank handle backing plate
Post by: USMC Vet on May 31, 2007, 04:12:53 pm
Heres a few. I have got to do something with the coin mech. housing, plate or paint ?
Title: Crank handle backing plate
Post by: collecture on May 31, 2007, 05:02:50 pm
Here's what you are looking for!
I am pretty sure reproductions are available from The Soad Jerk Works.
I am pretty sure reproductions are available from The Soad Jerk Works.